Initial commissioning
30
Refilling the salt
Fill the salt reservoir with reactivation
salt when Refill salt and start the
“QuickIntenseWash” program with the
“Express” option without a load appears
in the display.
Confirm with OK.
The salt refill indicator will go out.
Danger of corrosion due to saline
solution.
Salt solution that runs out can cause
corrosion in the wash cabinet and to
the wash items.
Each time you remove the salt
reservoir cap, you must run the
65°C QuickIntenseWash program
with the Express program option
selected without wash items in the
dishwasher. This will dissolve and
remove any traces of salt from the
wash cabinet.
After the salt reservoir has been filled,
the refill indicator may still appear in the
display if the salt concentration has not
yet reached the correct level. In this
case, still confirm the message again
with OK.
The salt refill indicator will be turned off
if you have programmed the dishwasher
for a water hardness below 5gr/gal
(5°dH).
To Next Page
Need help?
General
