Installation
-
I
N
-
S
T
A
L
L
-
A
-
T
I
O
N
-
81
Installing the oven
For safety reasons, the oven may
only be used when it has been fully
installed.
The oven requires a sufficient supply
of cool air for efficient operation. The
required supply of cool air must not
be excessively heated by other heat
sources (e.g. solid fuel stoves).
The following must be observed
when installing the appliance:
Make sure that the shelf that the
oven sits on does not touch the wall.
Do not fit heat insulation strips to the
side walls of the housing unit.
Connect the oven to the electrical
supply.
Do not carry the oven by the door
handle. The door can be damaged.
Use the handle cut-outs on the side
of the housing to lift the appliance.
It is a good idea to remove the door
(see “Cleaning and care” – “Door re-
moval”) and to remove the accessor-
ies before installing the appliance. This
makes the oven lighter when you push
it into the housing unit and you do not
run the risk of lifting it by the door
handle by mistake.
Push the oven into the housing unit
and align it.
Open the door, if you have not re-
moved it.
Use the screws supplied to secure
the oven to the side walls of the
housing unit.
Refit the door if necessary (see
“Cleaning and care” – “Fitting the
door”).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
