Before using for the first time
27
Add salt reminder
When Insufficient salt appears in the
display wait until the end of the pro-
gramme and then refill the salt reser-
voir.
Confirm with OK.
The message will go out.
Risk of corrosion.
Immediately after filling the salt
reservoir, run the QuickPowerWash
programme with the Short pro-
gramme option selected and without
any crockery in the dishwasher to re-
move any traces of salt from the cab-
inet.
After the salt reservoir has been filled,
the refill reminder may still appear in the
display if the salt concentration has not
yet reached the correct level. If this is
the case, confirm again with OK.
The refill reminder will be switched off if
you have programmed the dishwasher
for a water hardness below 0.9mmol/l
(5°d - German scale).
If you only ever use combination
products containing salt and rinse aid
in your dishwasher, you can switch the
reminders off if you wish (see "Set-
tings menu, Refill reminders").
If you switch to using detergent that
does not contain salt or rinse aid, it
is important to remember to add salt
and rinse aid and to switch the re-
minders back on.