Miele PG 8581 Supplementary Document

Powered by TCPDF (www.tcpdf.org)
MUW216743-2 15
4.6. At the end of the programme
Note: The Eschmann Dental or Eschmann W T D programme
will be available.
A programme is usually completed successfully when the
following parameters and messages are shown in the
display:
Display line Display content
Top line Programme name.
Middle line Continuously alternating between:
• (Parameter achieved)
• A
0
value
• Cycle number
Bottom line Programme nished.
The LED in the Start/Stop button also
goes out and the LED in the button
begins to ash. An acoustic tone also
sounds for approximately 10 seconds.
4.7. Cancelling a programme
Programme cancelled due to a fault
The programme stops and an error message appears in the
display.
Take appropriate steps to resolve the fault, depending on its
cause (see ‘Problem solving guide’).
Cancelling a programme manually
A programme which is already running should only be
cancelled if strictly necessary, e.g. if the wash load is moving
about signicantly.
Press and hold the Start/Stop button until the display
changes to the following view
Using the machine
21
Control panel
The machine is operated exclusively by the buttons located on the
stainless steel surfaces either side of the display. The display is not a
touch screen.
A light touch on the relevant button is sufficient to operate the
functions. The buttons can also be pressed and held for approx.
20 seconds.
Display illustrations
All display illustrations shown in these operating instructions are
examples which can be different from the actual display screens
shown.
Vario TD Dental
Temperature
Duration
Min50
55 °C
The control buttons are shown next to the display. The ,  and
Start/Stop buttons are not shown.
Eschmann W T D
Temperature 55˚C
Duration 50Min
Operation
59
Cancelling a programme
 If a programme is cancelled, the items in the washer-disinfector
must be reprocessed again.
 Be careful when opening the door.
The wash load could be hot. Danger of scalding, burning and
chemical burns.
The programme stops and an error message appears in the display.
Take appropriate steps to resolve the fault, depending on its cause
(see "Problem solving guide").
A programme which is already running should only be cancelled if
strictly necessary, e.g. if the wash load is moving about significantly.
 Press and hold the Start/Stop button until the display changes to
the following view:
Cancel programme
No
Yes
 Select Yes using the  and  arrow buttons.
 The programme is cancelled when the OK button is pressed. Entry
of a code may also be required (see "Further settings / Code")
If no button is pressed for several seconds, or if the process is
cancelled using the  button, the display will revert to the
programme sequence display.
 Before starting the programme, check to see whether any more
powder cleaning agent is required.
 Start the programme again or select a new programme.
Programme
cancelled due to a
fault
Cancelling a
programme
manually
Restarting the
programme
Select Yes using the UP and DOWN buttons (∧ ∨).
The programme is cancelled when the OK button is pressed.
Entry of a code will also be required. Refer to 6.4 Advisory
codes (Cycle interrupts).
If no button is pressed for several seconds, or if the process
is cancelled using the OK button, the display will revert to the
programme sequence display.
Restarting the programme
Start the programme again or select a new programme.
WARNING!
HEALTH HAZARD
If the programme is cancelled, the items in the
washer disinfector must be reprocessed again.
WARNING!
PERSONAL INJURY HAZARD
Be careful when opening the door.
The wash load could be hot. Danger of scalding,
burning and chemical burns.

Miele PG 8581 Specifications

General

Model Number	PG 8581
Brand	Miele
Color	Stainless Steel
Programs	Multiple programs
Dimensions (H x W x D)	835 mm x 600 mm x 600 mm