Miele PW 6101 Programming Instructions

Block programmimg
Block programming is used for specifying
the individual steps in the blocks. The blocks
for the individual areas are all identical and
contain the same basic parameters.
Programme block
Step Standard settings
Block name 20 empty spaces
1. Block activation No
2. Programme stop 1 No
3. Programme stop signal 1 No
4. Heating No
5. Free temperature selection No
6. Temperature Cool air
7. Hysteresis Normal
8. Warm up X
9. Water level 1 0 mm/0l/1:0kg/l
10. Water inlet 1 Automatic
11. Dispensing method No
12. Dispensing phase 1 X
13. Dispensing stop 1 X
14. Agitation from level Automatic
15. Water level stop 1 No
16. Wash time 1 No
17. Thermo stop X
18. Water level 2 0 mm
19. Water inlet 2 Automatic
20. Dispensing phase 2 X
21. Dispensing stop 2 X
22. Water level stop 2 No
23. Wash time 2 No
24. Cool down No
25. Wash time 3 No
26. Programme stop 2 No
27. Programme stop signal 2 No
28. Drain path 1 No
29. Drain level 0 mm
30. Wash time 4 No
31. Drain path 2 Drain
32. Free spin speed selection No
33. Spin No
34. Repeat No
35. Block end signal No
X "locked" appears if the dispensing type
has been programmed to "No" in the
respective programme.
Block name
Block programming ~ Block parameter
Block name:
1. 1. Block activation: No e
-e SA
Enter a name for the block.
1. Block activation
At the start of programming each block a
decision needs to be made about the
activation status of the block.
Selection choice:
–
No
The programme block is not carried out.
–
Permanent
The programme block is a fixed part of the
programme structure and is always carried
out.
– Block+
The programme block is only carried out if
the + i "Block+" button is pressed.
Programming
20 M.-Nr. 06 533 430

Miele PW 6101 Specifications

General

Brand	Miele
Model	PW 6101
Category	Washer
Language	English