Settings
This menu is used for copying all settings
from the supervisor level (see "Settings"
menu) on the control unit to a card. Existing
settings are only overwritten after another
confirmation to do so.
Main menu ~ Data to card
Programme -
Settings
A
^
After making your selection and pressing
the "Start" h button the following display
will appear:
Data to card ~ Settings
D
A
If settings data already exists on the card
the following message will appear in the
display:
Data to card ~ Settings
Overwrite existing data?
S A
^ Press the S "Save" button to overwrite the
existing data.
If you press the A button or, if you do not
touch any buttons in the next 30 seconds the
overwriting procedure will not be carried out
and you will be taken back to the sub menu.
Data to control unit
Use this menu to write data from a card to
the control unit (language, dispensing
data, programme and settings).
Supervisor level ~ Main menu
Data to control unit -
Delete data from card
A
Selection choice: - Data to card
- Data to control unit - Delete data from card
^
After making your selection and pressing
the "Start" h button, the display will show
what is on the card.
Language
If a language has been saved to the card
the following will appear in the display:
Data to control unit ~ Language
Language on card: english (GB)
Overwrite language: english (GB)
A
^ After making your selection and pressing
the rotary dial the following will appear in
the display:
Data to control unit ~ Language
D
A
If there is already a language in the selected
position in the control unit the following
message will appear in the display:
Data to control unit ~ Language
Overwrite existing data?
S A
^
Press the S "Save" button to overwrite the
existing data.
If you press the A button or, if you do not
touch any buttons in the next 30 seconds the
overwriting procedure will not be carried out
and you will be taken back to the sub menu.
Chip cards
M.-Nr. 06 533 430 39
To Next Page
Loading...
Need help?
General
