Cards on which a programme has been
saved can only be used on the machine
type for which they have been written.
Unwritten cards can be used universally.
^ Press the "On" I button to switch the
machine on.
The Welcome screen will appear.
^ Insert the card in the reader.
The programmes listed on the card will
appear in the display.
Card operation
17 Masks 45 °C
18 Minimum iron 60 °C
i ßFC A
^ Use the rotary dial to highlight the
programme you want to use. Press the
rotary dial to select the programme you
have highlighted.
^ Press the START button. The programme
will start.
After pressing the START button you can
remove the card from the reader. The
programme is deleted from the machine's
memory once it has finished.
,
Never insert any other type of card or
object into the card reader!
If the card is inserted the wrong way round
the following message will appear in the
display:
§
Card fault
Card incorrectly inserted in card reader.
A
^ Insert the card the right way round in the
card reader.
If the card is not the right one for the
machine it is being used in the following
message will appear in the display:
Card contents
Programmes on the card are
only suitable for machine type PW 6161.
A
^ Insert the correct card for the machine in
the card reader.
Card access operation
Programmes requiring special procedures
are written on to a card which is then used to
run the programme.
"Card access" has to be activated via the
supervisor level in the machine.
The machine will then only run programmes
by using a card (on which one programme
has been saved). Programmes in the
machine's control unit cannot then be
accessed.
Card operation
M.-Nr. 06 572 495 19
To Next Page
Loading...
Need help?
General
