Service interval
If after switching the machine on the
following message appears in the display
the machine will need to be serviced by the
Miele Service Department.
§
Service interval 1
Call the Service Department
A
The display will go out after 5 minutes.
Error messages
,
Repairs to electrical, gas or steam
operated machines may only be carried
out by a suitably qualified person in
accordance with national and local safety
regulations. In the U.K. repairs to gas
heated machines must only be carried out
by a Gas Safe registered technician.
A message will appear in the display if there
is a problem either before starting a
programme or once it has started:
The display remains dark.
There is no power to the machine.
^ Check the mains switch and the on-site
fuses.
y
Power cut
Programme stop
Press the start button.
f
^ Once power has been restored press the
START button.
This error message can also indicate that
the winding on the motor has overheated.
^
Allow the motor to cool down.
M
Water inlet fault
Call the Service Department
if restart does not work.
if
^ Check the stopcock and then press the
START button.
a
Door lock fault
Call the Service Department
if restart does not work.
if
^ Push firmly on the door handle until you
hear the lock engaging. Confirm by
pressing START.
§
Heating system fault
Programme stopped. Press start.
Programme will continue without heat.
if
^ To continue the programme with heating
press the START button. If a disinfection
programme was running the programme
will be cancelled if this message appears.
Call the Service Department.
m
Drive motor fault
Programme stopped. Press the start button.
Motor overheating.
if
^ Allow the motor to cool down.
§
Imbalance fault
Call the Service Department
if restart does not work.
i A
The imbalance is too great and the
imbalance switch has been activated.
^
Switch the machine off and on again. Then
press the START button.
Problem solving guide
M.-Nr. 06 572 495 31
To Next Page
Loading...
Need help?
General
