Guide to the appliance
20
Display functions
The display is used to select or set the
following:
- The programme
- The timer
- The Settings
The display can show the following:
- The stage the programme is at
- The estimated time left for the pro-
gramme to run
- The energy and water consumption
(EcoFeedback)
- Any relevant fault messages and in-
formation
To save energy, the dishwasher
switches off after a few minutes if you
do not press any sensor controls dur-
ing this time.
Touch the sensor control to switch
the dishwasher back on.
The OKsensor control is used to con-
firm a message or setting and also to
move to the next menu or another level.
Under Further programmes/settings
the right of the display will show a scroll
bar. This offers further options. These
options can be shown using the
sensor controls.
You can alter the dishwasher’s controls
to suit changing requirements in the
Settings menu (see “Settings” chapter).
The option that is selected will have a
tick next to it.
To exit a sub-menu again use the
Backsensor control.
If you do not press any sensor controls
for several seconds, the display will re-
vert to the previous menu. You may
then have to enter your settings again.
To Next Page
Loading...
Need help?
General
