Settings
43
Display brightness
You can set the display brightness to
one of seven different levels.
Volume
A sequence of buzzer tones will sound
at the end of the programme or if there
is a fault as long as the buzzer se-
quence has been activated.
Buzzer in the event of a fault
In the event of a fault, the warning
buzzer will sound four times at intervals
with a short pause between each set of
tones.
The warning buzzer that sounds
when there is a fault cannot be deac-
tivated.
Buzzer tones
The buzzer at the end of a programme
will sound four times at intervals with a
short pause between each set of tones.
The volume of the buzzer at the end of
the programme can be selected from
one of seven levels. If no volume is se-
lected, the buzzer is switched off.
Keypad tone
An audible tone sounds each time a
sensor control is pressed.
The volume for the keypad tone can be
set to one of seven different levels. If no
volume is selected, the keypad tone is
switched off (except the On/
Offsensor control).
Welcome melody
If you switch the dishwasher on or off, a
brief melody will sound.
You can switch the melody off.
To Next Page
Loading...
Need help?
General
