Operation
68
Switching on the dishwasher
Open the stopcock, if it is closed.
Open the door.
Make sure the spray arms can rotate
freely.
Touch the sensor control.
If the dishwasher has been switched
off for longer than 1minute, you will
need to hold the sensor control for
a bit longer (wipe protection).
The programme selected will appear
briefly in the display and the appropri-
ate sensor control will be illuminated.
Next, the estimated energy and water
consumption may be shown for the
chosen programme for several
seconds.
Then the display will show the estim-
ated duration for the selected pro-
gramme.
Selecting a programme
Choose your programme according to
the type of crockery and the degree of
soiling.
The different programmes and their
uses are described under “Programme
overview”.
Touch the sensor control for the re-
quired programme.
The sensor control for the selected pro-
gramme will light up.
Further programmes can be selected
under .
To do so, touch the sensor con-
trol.
The first of the further programmes will
appear in the display.
Use the sensor controls in the
display to select the programme you
want.
You can now select programme options
(see “Programme options”).
If any programme options are selected,
the appropriate sensor controls will also
light up.
To Next Page
Loading...
Need help?
General
