Miele T 7950 WP User Manual

The following information appears in
the display:
–
Programme duration
–
Programme sequence
Drying
Cooling down
Finish
–
Check and fault messages
The following can be set via the
display:
–
Programme duration for Warm air
–
Delay start
You can set a programme to start
automatically at a later time.
– Programmable functions
The programmable functions are
used to alter the machine's
electronics to suit changing
requirements. See "Programmable
functions" later in this booklet for
more details.
Perfect Dry indicator light
The Perfect Dry system measures the
laundry's residual moisture in
programmes with drying levels and
provides a more precise drying result.
After starting the programme, the
electronics will measure the duration of
the programme (Estimated time
remaining). The Perfect Dry indicator
light will flash during this time.
The programme duration will be shown
after a short time and the indicator light
will go out.
Once the selected drying level has
been reached, the Perfect Dry indicator
light will remain on until the end of the
programme.
The Perfect Dry indicator light remains
dark during the following time
controlled programmes: Woollens,
Warm air, Gentle smoothing.
Estimated time remaining
The expected time will automatically be
displayed (Estimated time remaining).
The following factors all affect the
estimated time remaining: residual
moisture content after spinning; type of
fabric; size of load; room temperature
or fluctuations in the power supply.
The electronics continually assess
conditions in the tumble dryer and
adjust the estimated time remaining for
a more accurate reading. Because of
this, the time displayed can alter during
the course of a programme.
In the same way, programmes may
finish early. This can happen with
particularly fine fabrics, very small
loads or if items were partly dry
beforehand.
Before using for the first time
,
Install and connect the tumble
dryer according to the descriptions
in these operating instructions. If the
tumble dryer has not been
transported as described, then it
must be left to stand for at least 1
hour before it is connected to the
electricity supply.
Operating the tumble dryer
16

Miele T 7950 WP Specifications

General

Brand	Miele
Model	T 7950 WP
Category	Dryer
Language	English