Replacing the fine filter
^
Insert the handle into the fine filter.
In order that the filter sits correctly in
front of the heat exchanger unit:
^
Stick the handle with the filter
attached onto the two guide pins.
Ensure that the yellow dot is on the
right-hand side of the handle.
^
Push the handle in as far as it will go.
^
Close the cover panel.
Only when the filter is fitted correctly
and the cover panel is closed can
the condensed water system be
sealed and the correct functioning of
the tumble dryer be guaranteed.
Cleaning the tumble dryer
Disconnect the machine from the
mains electricity supply.
^
Clean the housing, control panel and
door seal with a slightly damp cloth
and a mild detergent or soapy water.
^ The drum and other stainless steel
parts can be cleaned with a suitable
propietary stainless steel cleaner
following the manufacturer's
instructions.
Do not use solvents, abrasive
cleaners, glass cleaners or
all-purpose cleaners. These could
damage plastic surfaces and other
parts.
^
Dry all parts with a soft cloth.
Cleaning and care
32
To Next Page
Loading...
Need help?
General