Problem solving guide
Most faults can be resolved by yourself. This will save time and money as a
call-out charge will apply to customer service visits where the problem could have
been rectified as described in these Operating instructions.
With the help of the following notes, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without a call-out being necessary. Please note:
,
Repair work to electrical appliances must only be carried out by a suitably
qualified and competent person in strict accordance with current local and
national safety regulations. Repairs and other work by unqualified persons
could be dangerous. The manufacturer cannot be held liable for unauthorised
work.
Check and fault messages in the display
Problem Possible cause Remedy
0-§ appears in the
display.
The Low temperature
indicator light is
flashing.
The system lock is
activated.
If you wish to use the tumble
dryer, the system lock needs
to be deactivated (see
"Electronic system lock").
The programme is
cancelled.
0 and Finish appear in
the display.
The buzzer sounds.
This is not a fault.
In some programmes, if
the drum has been
overloaded or
underloaded, the
programme will be
cancelled. This can
also happen if the items
are already dry.
Use the Warm air programme
to dry individual items.
–
Open and close the door.
The programme is
cancelled.
The buzzer sounds.
Cooling down or
Finish is flashing in
the display.
There is no immediate
cause.
–
Switch the dryer off and
then on again.
–
Start a programme.
If the programme stops again
and Cooling down or Finish
flashes again, there is a fault.
Contact Miele.
Problem solving guide
33
To Next Page
Loading...
Need help?
General
