Adjusting the dryer's
electronics for very soft water
,
Extremely soft water can affect
the sensitivity of the control
electronics.
Important
If the dryer is installed in an area with
very soft water, you should contact your
local water supplier for information and
advice regarding water hardness and
water conductivity.
If the water conductivity is less than 150
µS, the following programmable
function will need to be activated.
This programmable function should
not be activated if, despite the water
being extremely soft (as would be
the case if a water softener were
used), its conductivity is greater
than 150 µS.
Otherwise, the drying result will not
be satisfactory.
Follow steps (A,B,C ...) to
programme and store in memory.
Before you begin, first ensure that:
–
The dryer is switched off.
–
The door is closed.
A Press the Start/Stop button and keep
it pressed in whilst carrying out steps
B-C.
B Switch the dryer on.
Wait until the indicator light for
the Start/Stop button lights up
constantly...
C . . . and then release the Start/Stop
button.
D Press the Low temperature button
ten times.
–
The indicator light Low temperature
will flash on and off slowly once and
will then flash on and off quickly
twice.
The option selected will be displayed
by a number which will alternate with
P.
0 Default setting
I Adjusted for very soft water (with
low conductivity)
(The Automatic plus indicator light
will also flash.)
E Pressing the Start/Stop button
switches from one to the other.
F Switch the dryer off.
The settings have been changed. You
can alter the settings again at any time.
Control
^
Repeat steps A to D.
^
Switch the dryer off after step D.
Programmable functions
61
To Next Page
Loading...
Need help?
General
