Other problems
Problem Possible cause Remedy
The drying process
goes on too long or
even switches off.
In some circumstances, the
Clean out airways indicator
light still comes on, even
though the filters are clean.
Clean out airways.
Please check all the
possible causes and
switch the dryer off and
then back on again.
Ventilation to and from the
dryer may be insufficient
(e.g. because it is installed
in a small room). This has
caused the temperature in
the room to rise sharply.
Open a door or window
while the machine is in
operation for increased air
flow.
The vents below the door
are covered.
– Remove any fluff.
The fluff filters are clogged
with fluff or were still wet
when they were replaced.
– Remove any fluff.
– The fluff filters need to
be dry.
Detergent residue, hair and
fine fluff can block the
condenser unit.
The condenser unit should
be checked and cleaned
from time to time.
The laundry has not been
spun sufficiently.
Make sure that your
laundry is thoroughly spun
at the appropriate spin
speed in the washing
machine.
The tumble dryer has been
overloaded.
Do not exceed the
maximum load for the
programme selected.
Metallic components, e.g.
zippers have prevented the
dryer from registering the
correct moisture level.
–
Open the zippers next
time.
If the problem occurs
again, dry garments with
long zippers using the
Warm air programme
(timed drying).
Problem solving guide
37
To Next Page
Loading...
Need help?
General
