Problem solving guide
59
Other problems
Problem Cause and remedy
The drying process
goes on
too long or
even switches off *
The room in which the dryer is located is too warm.
V
entilate the room thoroughly.
Detergent residues, hair and fine fluff can clog the fil‐
t
ers.
Clean
the fluff filters and the plinth filter.
Remove any visible fluff:
. .
. bottom left, from behind the panel in the heat
exchanger cavity (see "Cleaning and care");
. . . from the cooling fins behind the grill bottom
right (see the end of this section).
The cool air intake (bottom right grille) is blocked.
Move any objec
ts, such as a laundry basket, away
from the grille.
The fluff filters and the plinth filter were wet when re‐
placed.
The fluff filt
ers and the plinth filter must be dry.
The laundry is too damp.
Mak
e sure that your laundry is thoroughly spun at
the appropriate spin speed in the washing ma‐
chine.
The tumble dryer has been overloaded
Do not e
xceed the maximum load for the pro‐
gramme selected.
Metallic components, e.g. zips have prevented the
dr
yer from registering the correct moisture level.
Op
en the zips next time.
If
the problem recurs, dry these items using the
Warm air timed drying programme.
* Before starting another programme:
Switch the dr
yer off and then on again.
To Next Page
Loading...
Need help?
General
