Settings menu
79
– Light
Clean out airways appears when
ther
e is only a small build-up of fluff.
Buzzer volume
The buzzer can be set to be louder or
quiet
er.
The setting selected is shown in a bar
char
t.
Factory default: a medium setting.
– Quieter
– Louder
You will hear the buzzer change as the
setting
is selected.
Keypad tone
When this function is activated a tone
will sou
nd each time a button is press‐
ed.
Options
– On
– Off (factory default)
Conductivity
In some ar
eas of the UK, water is
extremely soft which can affect the
sensitivity of the electronics. If the
dryer is installed in an area with very
soft water, you should contact your
local water supplier for information
and advice regarding water hardness
and water conductivity. If the water
conductivity is less than 150 μS, the
Low option for the Conductivity set‐
ting will need to be activated.
Options
– Normal (factory default)
– Low
Important
This option should not be activated if,
despit
e the water being extremely soft
(as would be the case if a water soften‐
er were used), its conductivity is greater
than 150 μS.
O
nly activate the Low option if
the above conditions are present.
Otherwise drying results will be un‐
satisfactory.
Total consumption
You can display the total consump‐
tion.
Options
– Display
Th
e total consumption is displayed in
kWh.
– Reset functions
Th
e total consumption to date will be
deleted with the
Reset option.
To Next Page
Loading...
Need help?
General
