– 21 –
GB
8If the set settings need to be changed, repeat steps 4 to 7.
To complete the settings, press the [MODE] and the [ FAN] buttons at the same time for two
seconds or longer.
■ Checking the indoor unit Function Setting Value
1Perform the Procedure A on the previous page.
2Press the [TEMP. ] and the [TEMP. ] buttons to set the address of the indoor unit whose
settings to be checked. (0 to 50)
3Press the [MODE] button, then press the [TEMP. ] and the [TEMP. ] buttons to set the
Function Setting No. to be checked. (000 to 255)
4Press the [ FAN] button to display the current Function Setting Value.
2 sec.
[MODE]
+
[FAN]
Response has been received.
[TEMP. ] [TEMP. ]
[MODE]
Indoor unit address setting Function Setting No. setting Function Setting Value setting
The setting for the specified
Function Setting No. has not been
completed.
Setting completed
The specified indoor unit does not
exist.
Waiting for response
Response has been received.
[MODE]
[ON/OFF]
No
response
To Next Page
Loading...
Need help?
General
