30
1
3
F1 F2 F3 F4
Weekly timer
Select:
Cursor
Weekly timer No / Yes
The screen to enable (Yes) and disable (No) the
weekly timer will appear.
To enable the setting, move the cursor to "Yes"
with the F3 or F4 button, and press the
SELECT button.
Controller operation-Function settings
F1 F2 F3 F4
Main
Main display:
Cursor Page
Main menu
Vane·Louver·Vent. (Lossnay)
High power
Timer
Weekly timer
OU silent mode
Select "Weekly timer" from the Main menu (refer
to page 20), and press the SELECT button.
2
F1 F2 F3 F4
Weekly timer
Setting display:
day Page
Mon Tue Wed Thu Fri Sat Sun
No.
The current settings will appear.
Press the F1 or F2 button to see the settings
for each day of the week.
Press the F4 button to see patterns 5 through 8.
Press the SELECT button to go to the setting
screen.
Weekly timer
P
The Weekly timer will not work in the following cases:
when the On/Off timer is enabled, when the weekly timer
is disabled, during an error, during check (in the service
menu), during test run, during remote controller diagnosis,
when the clock is not set, during Function setting, when
the system is centrally controlled (On/Off operation,
temperature setting, or Timer operation from local remote
controller is prohibited).
Main
Button operation
To Next Page
Loading...
Need help?
General
