14
HeatHeat
Auto
VaneVane
72
ModeMode MenuMenu FanFan
Key Features
Note: The screen will wake up by pressing the center area of the displayed temperature.
The screen will stay lit for 10 seconds.
System Status Information
Cool On, Heat On, Standby.
Schedule Information
Following time-based
temperature control.
Desired Temperature
Displays the current desired
temperature setting.
Indoor Temperature
Displays the current indoor
temperature.
Indoor Temperature
Reminder:
The indoor temperature
display will show the
temperature from the indoor
unit, the MHK2 controller,
indoor air sensor(s), or an
average of all them. You
confirm and configure this
setting during installation
setup.
Vane
Touch to select air direction:
Auto, Swing, Ceiling, High,
Middle, Low, Floor.
Mode
Select system Mode: Heat,
Cool, Dry, Fan, Auto, Off.
Lock
Indicates the screen is
locked: Full Lock, Partial
Lock, and ISU-based locks.
Full and Partial Lock can be
unlocked with a PIN.
RedLINK™ Wireless
Communication Status
Indicates if the controller is
connected to the RedLINK™
interface and communicating
correctly.
Connection Status
Information
Indicates if the MIFH2
RedLINK™ Wireless Receiver
is connected to the Mitsubishi
Electric Wireless Interface 2
and kumo cloud
®
.
Messaging
Shows device setup options,
menu options, reminders,
schedule overrides.
Schedule Period
Shows schedule period: Wake,
Leave, Return, Sleep.
Fan
Select Fan speeds: Auto, 1-5.
Menu
Touch to display options.
Start here to set a program
schedule.
Note: Long press the Menu
button for 5 seconds to
access Advanced Menu
options.
Time, ISU #,
or Alert #
33-00446EFS_B.indd 14 10/17/2019 3:09:01 PM
To Next Page
Loading...
Need help?
General
