Mitsubishi Heavy Industries RC-EXZ3A User Manual

− 58−
1
When you press the
F1
(
F2
) switch, the operation mode, set
temp, fan speed,
flap direction
registered to Favorite set 1 or
Favorite set 2 will be enabled.
■ Operation will start even if you press the
F1
(
F2
) switch while the unit is
stopped.
■<RXFDQFKDQJHWKHRSHUDWLRQPRGHVHWWHPSIDQVSHHGÀDSGLUHFWLRQDIWHU
the operation has started with the favorite setting operation.
■Following power on, the unit starts to operate initially with the following settings
for both Favorite set 1 and Favorite set 2.
Operation mode ...Cooling
Set temp ...28
°C
Fan speed ...3-speed
Flap direction ...Position 2 (☞page 11)
＊:KHQDQ)'.ZLWKDOHIWULJKWÀDSLVFRQQHFWHG
/HIWULJKWÀDSGLUHFWLRQ &HQWHU
3D AUTO ...Disabled
■:KHQ&KDQJHVHWWHPS&KDQJHRSHUDWLRQPRGH&KDQJHÀDSGLUHFWLRQ
Change fan speed are restricted by the Permission/Prohibition setting (☞page
UHVWULFWHGLWHPVZLOOQRWEHUHÀHFWHGWRWKH)DYRULWHVHWWLQJRSHUDWLRQ
Favorite setting operation
You can start an operation with the operation mode, set temp, fan speed, flap direction registered to Favorite set 1
and Favorite set 2.
Settings for the operation mode, set temp, fan speed, flap direction can be registered from Favorite setting on the
menu (☞page 57).
Favorite setting operation must be set to the F1
or F2 switch (☞page 71).
Menu
Direction
Cooling
16：32 (Mon)
F1: Favorite set 1 F2: Favorite set 2
Timer
In operation for running.
Set temp

Mitsubishi Heavy Industries RC-EXZ3A Specifications

General

Brand	Mitsubishi Heavy Industries
Model	RC-EXZ3A
Category	Remote Control
Language	English