NOTE
l
The outside rear-view mirrors cannot be fol-
ded or extended using the remote control
switch in the following conditions:
•
The key is left in the ignition switch.
•
A door or the tailgate is open or ajar.
l
The remote control switch will operate with-
in approximately 4 m from the vehicle.
However, the operating range of the remote
control switch may change if the vehicle is
located near a power station, or radio/TV
broadcasting station.
l
If either of the following problems occurs,
the battery may be exhausted.
•
The remote control switch is operated at
the correct distance from the vehicle, but
the doors and tailgate are not locked/
unlocked in response.
•
The indication lamp (3) is dim or does not
come on.
For further information, please contact
your MITSUBISHI MOTORS Authorized
Service Point.
If you replace the battery yourself, refer to
“Procedure for replacing the remote con-
trol switch battery” on page 3-06.
l
If your remote control switch is lost or dam-
aged, please contact your MITSUBISHI
MOTORS Authorized Service Point for a re-
placement remote control switch.
NOTE
l
If you wish to add a remote control switch,
we recommend you to contact a
MITSUBISHI MOTORS Authorized Serv-
ice Point.
A maximum of 8 remote control switches
are available for your vehicle.
Setting of door and tailgate un-
lock function (Except for vehi-
cles equipped with a Dead
Lock System)
E00310300257
The door and tailgate unlock function can be
set to the following two conditions.
Each time the door and tailgate unlock func-
tion is set, a chime will sound to tell you the
condition of the door and tailgate unlock
function.
Number of
chimes
Condition
One chime
All doors and the tailgate un-
lock
Two chimes Driver’s door unlock only
1. Remove the key from the ignition
switch.
2. Place the combination headlamps and
dipper switch in the “OFF” position, and
leave the driver’s door open.
3. Press and hold the LOCK switch (1) for
4 to 10 seconds and then also press the
UNLOCK switch (2) during this time.
4. Release in sequence the LOCK and UN-
LOCK switches within 10 seconds of
pressing the LOCK switch in step 3.
Procedure for replacing the re-
mote control switch battery
E00309501272
1. Before replacing the battery, remove
static electricity from your body by
touching a metal part such as a doorknob
of the room.
WARNING
l
Danger of explosion if battery is incor-
rectly replaced.
Replace only with the same battery or an
equivalent type.
CAUTION
l
When the remote control switch case is
opened, be careful to keep water, dust, etc.
out. Also, do not touch the internal compo-
nents.
Keyless entry system*
3-06
OGAE15E5
Locking and unlocking
3