The “ ” mark (A) in the instant fuel gauge
shows the average fuel consumption.
When the value of instant fuel consumption
surpasses the value of average fuel consump-
tion, the instant fuel consumption is dis-
played with a green bar graph.
Be conscious of maintaining the value of in-
stant fuel consumption below the value of
average fuel consumption, it can help you to
drive with the best fuel consumption.
NOTE
l
When the instant fuel consumption cannot
be measured, the bar graph is not displayed.
l
The display setting can be changed to the
preferred units.
The display setting can be changed to the
preferred units {km/L, mpg (US), mpg (UK)
or L/100 km}.
Refer to “Changing the function settings” on
page 5-13.
l
It is possible to cancel the green bar graph.
Refer to “Changing the function settings” on
page 5-13.
Auto Stop & Go (AS&G) moni-
tor
E00531101071
The accumulated time the engine has been
stopped by Auto Stop & Go (AS&G) system
is displayed.
Refer to “Auto Stop & Go (AS&G) system”
on page 6-24.
NOTE
l
When the ignition switch or the operation
mode is ON again, the accumulated time
will be reset.
ECO mode indicator*
E00529300200
This indicator will be dis-
played when fuel-efficient
driving is achieved.
ECO Drive Assist
E00531501192
This function displays how fuel-efficiently
you are driving under different driving condi-
tions.
The ECO drive assist display will change as
follows if you do fuel-efficient driving using
the accelerator in a way well matched with
the vehicle speed.
NOTE
l
On vehicles with CVT, the ECO drive assist
is displayed only when the vehicle is driven
with the selector lever in the “D” (DRIVE)
position or when the vehicle is driven in the
sport mode (for vehicles equipped with shift
paddles).
Multi-information display
5-12
OGKE18E1
Instruments and controls
5
To Next Page
Loading...
Need help?
General
