In the main gate, the selector lever has four
positions, and is equipped with a lock button
(D) to avoid inadvertent selection of the
wrong gear.
The lock button must be pushed
while the brake pedal is depressed
to move the selector lever.
The lock button must be pushed to
move the selector lever.
The lock button need not be pushed
to move the selector lever.
WARNING
l
If the lock button is always pushed to op-
erate the selector lever, the lever may be
accidentally shifted into the “P” (PARK)
or “R” (REVERSE) position. Be sure not
to push the lock button when performing
the operations indicated by in the illus-
tration.
l
Always depress the brake pedal when
shifting the selector lever into the other
position from the “P” (PARK) or “N”
(NEUTRAL) position.
Never put your foot on the accelerator
pedal while shifting the selector lever
from the “P” (PARK) or “N” (NEU-
TRAL) position.
NOTE
l
To avoid erroneous operation, move the se-
lector lever firmly into each position and
briefly hold it there. Always check the posi-
tion shown by the selector lever position dis-
play after moving the selector lever.
l
If the brake pedal is not depressed and held,
the shift-lock device activates to prevent the
selector lever from being moved from the
“P” (PARK) position.
When the selector lever cannot
be shifted from the “P” (Park)
position
E00629001540
When the selector lever cannot be shifted
from the “P” (PARK) position to another po-
sition while the brake pedal is pressed and
held down with the ignition switch at the
“ON” position or the operation mode in ON,
the battery may be flat or the shift-lock
mechanism may be malfunctioning. Immedi-
ately have your vehicle checked by a
MITSUBISHI MOTORS Authorized Service
Point.
If you need to move the vehicle, shift the se-
lector lever as follows.
1. Make sure the parking brake is firmly
applied.
2. Stop the engine if it is running.
INVECS-III CVT with 8-step Sports Mode*
6-31
OGKE18E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
