Mitsubishi HC7000 User Manual

EN-21
How to change the settings:
With the remote control:
Press the ASPECT button.
Every time the ASPECT button is pressed, the aspect mode changes from AUTO to 4:3, 16:9, to ZOOM1, to
ZOOM2, to STRETCH, to ANAMORPHIC1, to ANAMORPHIC2, and back to AUTO.
Some modes are not available with certain signals.
With the FEATURE menu:
(See page 26 for menu setting.)
Display the FEATURE menu.
Select ASPECT by pressing the S or T button.
Select your desired aspect ratio by pressing the W or X button.
To cancel the menu:
Press the MENU button.
Important:
When a 4:3 or 2.35:1 (CinemaScope) image is kept displayed for a long time before displaying 16:9 image, the
afterimages of the black bars may appear on the 16:9 image screen. (See page 41.)
1.
•
•
1.
2.
3.
4.
•
FE A TURE
AUTO
opt.
ASPECT
A V MEMO R Y 1
Viewing video images (continued)

Mitsubishi HC7000 Specifications

General

Matrix size	0.7 \
Vertical scan range	50 - 120 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	-
Screen size compatibility	50 - 300 \
Keystone correction, vertical	-15/15 °
Lamp power	160 W
Light source type	Lamp
Service life of light source (economic mode)	5000 h
Focal length range	23.5 - 37.6 mm
Audio input	1
Dimensions (WxDxH)	427 x 440 x 159 mm
Power requirements	AC 100-240V, 50/60Hz
Connectivity technology	Wireless
Noise level	17 dB
Dot clock scanning frequency	162 MHz
Full HD	No
Analog signal format system	NTSC, PAL, SECAM
Serial interface type	RS-232
Power consumption (typical)	250 W

Weight and Dimensions

Weight	7500 g