Mitsubishi HC7000 User Manual

EN-9
30°30°
30°30°
Operational range of the remote control
Vertical directions (ceiling mount)
Reception angle
Vertical directions
When operating the remote control, keep the distance
from the remote control to the projector via the screen
within about 5 m (15 feet). The operable range of the
remote control, however, depends on the characteristics
of the screen.
Operate the remote control
within a distance of 10 m
(30 feet) from the projector,
pointing the IR beam at the
remote control photo-sensor
(front or rear) of the projector.
Keep the remote control photo-sensor out of direct
sunlight or fl uorescent lamp light.
Keep the remote control photo-sensor at least 2 m
(6 feet) away from fl uorescent lamps. Otherwise,
the remote control may malfunction.
If there is an inverter-operated fl uorescent lamp
near the remote control, the remote control
operation may become unstable.
When you use the remote control too close to the
remote control sensor, the remote control may not
work correctly.
•
•
•
•
Front of projector Rear of projector
Using the remote control
20°
10°
20°
10˚
20°
20°

Mitsubishi HC7000 Specifications

General

Matrix size	0.7 \
Vertical scan range	50 - 120 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	-
Screen size compatibility	50 - 300 \
Keystone correction, vertical	-15/15 °
Lamp power	160 W
Light source type	Lamp
Service life of light source (economic mode)	5000 h
Focal length range	23.5 - 37.6 mm
Audio input	1
Dimensions (WxDxH)	427 x 440 x 159 mm
Power requirements	AC 100-240V, 50/60Hz
Connectivity technology	Wireless
Noise level	17 dB
Dot clock scanning frequency	162 MHz
Full HD	No
Analog signal format system	NTSC, PAL, SECAM
Serial interface type	RS-232
Power consumption (typical)	250 W

Weight and Dimensions

Weight	7500 g