Mitsubishi HC7000 User Manual

EN-38
When removing the lamp from the ceiling-mounted projector
When removing the lamp from the ceiling-mounted projector, use the lamp replacement tray packed with the
projector or option lamp to prevent glass fragments from scattering.
Assemble the lamp replacement tray according to the procedure shown on it.
Follow steps 1 to 5 on page 37.
Attach the lamp replacement tray to the projector as shown in the
fi gure.
Secure the lamp replacement tray on the projector using the tape
packed with the tray.
Pull out the lamp box by the handle while holding the projector.
Hold the lamp replacement tray to prevent glass fragments
from scattering.
Don’t put the lamp directly on the lamp replacement tray
because it may fall.
Detach the lamp replacement tray together with the removed
lamp.
Follow steps 7 to 13 on page 37.
•
1.
2.
3.
4.
•
•
5.
6.
Replacing the lamp (continued)
Tape

Mitsubishi HC7000 Specifications

General

Matrix size	0.7 \
Vertical scan range	50 - 120 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	-
Screen size compatibility	50 - 300 \
Keystone correction, vertical	-15/15 °
Lamp power	160 W
Light source type	Lamp
Service life of light source (economic mode)	5000 h
Focal length range	23.5 - 37.6 mm
Audio input	1
Dimensions (WxDxH)	427 x 440 x 159 mm
Power requirements	AC 100-240V, 50/60Hz
Connectivity technology	Wireless
Noise level	17 dB
Dot clock scanning frequency	162 MHz
Full HD	No
Analog signal format system	NTSC, PAL, SECAM
Serial interface type	RS-232
Power consumption (typical)	250 W

Weight and Dimensions

Weight	7500 g