Mitsubishi HC7000 User Manual

EN-7
Overview
VIDEO IN and S-VIDEO IN terminals
COMPONENT VIDEO IN terminals
COMPUTER IN/COMPONENT VIDEO IN terminal (mini
D-SUB 15-pin)
HDMI IN-1 terminal (HDMI 19-pin)
HDMI IN-2 terminal (HDMI 19-pin)
SERIAL terminal (D-SUB 9-pin)
Used for projector control by computer. Contact your
dealer for details.
TRIGGER terminal
Used for the optional electric screen.
Power jack
1
2
3
4
5
6
•
7
•
8
POWER button
HDMI/COMPUTER/W button
AUTO POSITION/S button
LENS SHIFT button
MENU button
ENTER button
T button
ZOOM/FOCUS button
VIDEO/X button
1
2
3
4
5
6
7
8
9
Remote control sensor (front)
Lens
Right side panel (air inlet grille/fi lter)
Indicator area
Control panel
Terminal panel
Kensington Security Lock Standard connector
Remote control sensor (rear)
Left side panel (air outlet grille/lamp cover)
1
2
3
4
5
6
7
8
9
Terminal panel
Control panel
Preparing your projector (continued)
9
5
1
678
2
3
4
1 2 3 4
5 7698
12 3 4 5 6 7
8
Indicator area
12
STATUS indicator
POWER indicator
1
2


Attaching the lens cap
To attach the supplied lens
cap, push it into the lens
section of the projector (c)
and then turn it clockwise (d).
(For removal, turn it
counterclockwise.)

Mitsubishi HC7000 Specifications

General

Matrix size	0.7 \
Vertical scan range	50 - 120 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	-
Screen size compatibility	50 - 300 \
Keystone correction, vertical	-15/15 °
Lamp power	160 W
Light source type	Lamp
Service life of light source (economic mode)	5000 h
Focal length range	23.5 - 37.6 mm
Audio input	1
Dimensions (WxDxH)	427 x 440 x 159 mm
Power requirements	AC 100-240V, 50/60Hz
Connectivity technology	Wireless
Noise level	17 dB
Dot clock scanning frequency	162 MHz
Full HD	No
Analog signal format system	NTSC, PAL, SECAM
Serial interface type	RS-232
Power consumption (typical)	250 W

Weight and Dimensions

Weight	7500 g