To adjust the vertical mirror position
It
is possible to move the mirror up and down to ad-
just its position.
To adjust the mirror position
It
is possible to move the mirror up/down and left/
right to adjust its position.
To reduce the glare
Type 1
The
lever (A) at the bottom of the mirror can be
used to adjust the mirror to reduce the glare from
the headlamps of vehicles behind you during night
driving.
1- Normal
2-
Anti-glare
Type 2
When the headlamps of the vehicles behind you are
very
bright, the reflection factor of the rear-view
mirror is automatically changed to reduce the glare.
When the ignition switch is turned to the “ON” po-
sition,
the green indicator (1) illuminates and the re-
flection factor of the mirror is automatically
changed.
NOTE
l
Do not hang any items on, or spray glass clean-
er on the sensors (2) on the front and back
side, as reduced sensitivity could result.
l
If you want to stop automatic mode, press
the switch (3) and the indicator will go off.
To return to automatic mode, press the
switch again or turn the ignition switch to the
“ON” position after turning to “LOCK” or
“ACC” position.
Starting and driving
4-10
4
To Next Page
Loading...
Need help?
General
