NOTE
l
Press
and hold the DISP button (4) again un-
til you hear a beep, and the tag information
disappears.
l
Up to 10 characters are shown in the display
at once. If the title is cut off in the middle,
press the PAGE button (3). The next charac-
ters are displayed every time this button is
pressed.
l
If no title is stored, “NO TITLE” is shown in
the display.
l
Characters that cannot be displayed are sub-
stituted by “•”.
To use the external audio input
function*
E00732200784
Auxiliary Audio connector (RCA)*
A-
Left audio input connector (white)
B- Right audio input connector (red)
Auxiliary Video connector (RCA)*
A- Left audio input connector (white)
B- Right audio input connector (red)
C- Video input connector (yellow)
You can listen to commercially available audio
equipment,
such as a portable audio system, from
your vehicle’s speakers, by connecting the audio
equipment to the audio input connectors, which are
external input connectors (pin jacks).
NOTE
l
On vehicles equipped with the MITSUBISHI
Multi-Communication System (MMCS), re-
fer to the separate owner’s manual of the
MITSUBISHI Multi-Communication Sys-
tem.
To activate the external audio input
mode
1. Use a commercially available audio cable to
connect the audio equipment to the external
audio input connector.
2. Press the CD button (D) for more than 2 sec-
onds.
The display (E) will show “AUX” and then
the external audio input mode will be activa-
ted.
For pleasant driving
5-60
5
To Next Page
Loading...
Need help?
General
