Replacement of lamp bulbs
E01003100215
Before
replacing a bulb, ensure the lamp is off. Do
not touch the glass part of the new bulb with your
bare fingers; the skin oil left on the glass will evap-
orate when the bulb gets hot and the vapour will
condense on the reflector and dim the surface.
CAUTION
l
Bulbs
are extremely hot immediately af-
ter being turned off.
When replacing a bulb, wait for it to cool
sufficiently before touching it. You could
otherwise be burnt.
NOTE
l
If
you are unsure of how to carry out the
work as required, we recommend you to con-
sult a specialist.
l
Be careful not to scratch the vehicle body
when removing a lamp or lens.
l
When it rains or when the vehicle has been
washed, the inside of the lens sometimes be-
comes foggy. This is the same phenomenon
as when window glass mists up on a humid
day, and does not indicate a functional prob-
lem. When the lamp is switched on, the heat
will remove the fog. However, if water gath-
ers inside the lamp, we recommend you to
have the lamp checked.
Bulb capacity
E01003200173
When replacing a bulb, use a new bulb with the
same wattage and colour.
Outside
E01003302181
Except for vehicles equipped with high intensity
discharge headlamps
1.
Front turn-signal lamps: 21 W (WY21W)
2. Headlamps, high-beam: 60 W (HB3)
3. Headlamps, low beam: 51 W (HB4)
4.
Front fog lamps
*1
: 55 W (H11)
5. Position lamps: 5 W (W5W)
6.
Side turn-signal lamps
*2
: 5 W
Vehicles equipped with high intensity discharge
headlamps
1. Front turn-signal lamps: 21 W (WY21W)
2. Bending lamps (Adaptive Front lighting Sys-
tem (AFS)): 55 W (H11)
3. Headlamps, high/low beam (Discharge
bulb)
*2
: 35 W
4.
Front fog lamps
*1
: 55 W (H11)
5. Position lamps: 5 W (W5W)
6.
Side turn-signal lamps
*2
: 5 W
*1
If so equipped
*2
Have
the lamps bulbs replaced at a
MITSUBISHI MOTORS Authorized Service
Point.
Codes in parentheses indicate bulb types.
WARNING
l
Check
with a MITSUBISHI MOTORS
Authorized Service Point when it is neces-
sary to repair a high intensity discharge
headlamp or to replace the bulb. The pow-
er circuit, bulb and electrodes generate
high voltages that may cause a severe
shock.
NOTE
l
For
the side turn-signal lamp, it is not possi-
ble to repair or replace just the bulb.
Check with a MITSUBISHI MOTORS Au-
thorized Service Point when the lamp needs
to be repaired or replaced.
7. High-mounted stop lamp
8.
Rear fog lamp: 21 W (W21W)
9. Licence plate lamps: 5 W (W5W)
10. Reversing lamps: 16 W (W16W)
11. Stop and tail lamps: 21/5 W (W21/5W)
12. Rear turn-signal lamps: 21 W (WY21W)
Maintenance
8-28
8
To Next Page
Loading...
Need help?
General
