11 - 12
11. TROUBLESHOOTING
11.3.2 Error code list for the AnUCPU, A2US(H)CPU, A2ASCPU and A2USH board
The following table shows the error messages, error codes, error definition and cause of
error and corrective actions of detailed error codes. (*: The detailed error codes added to
AnUCPU, A2USCPU, A2ASCPU and A2USH board)
Table 11.1 Error Code List for the AnUCPU, A2US(H)CPU, A2ASCPU and A2USH board
Error Massage
Error
Code
(D9008)
Detailed
Error
Code
(D9091)
CPU
States
Error and Cause Corrective Action
"INSTRCT
CODE ERR"
(Checked when
STOP RUN
or at execution
of instruction.)
10 101 STOP Instruction codes which the CPU
cannot decode are included in the
program.
(1) Read the error step using a
peripheral device and correct the
program of the step.
(2) Check the ROM if it contains
instruction codes which cannot be
decoded. If it does, replace it with a
correct ROM.
102 Index qualification is specified for a 32-
bit constant.
Read the error step using a peripheral
device and correct the program of the
step.
103 Device specified by a dedicated
instruction is not correct.
104 An dedicated instruction has incorrect
program structure.
105 An dedicated instruction has incorrect
command name.
106 Index qualification using Z or V is
included in the program between
and .
107 (1) Index qualification is specified for
the device numbers and set values
in the instruction of timers and
counters.
(2) Index qualification is specified at the
label number of the pointer (P)
provided to the head of destination
of the , , , ,
, , and ,
instructions or at the label
number of the interrupt pointer (I)
provided to the head of an interrupt
program.
108 Errors other than 101 to 107 mentioned
above.
LEDA IX
LEDAIXEND
OUT
CJ
SCJ
CALL
CALLP
JMP LEDA/B
FCALL
LEDA/B
BREAK
To Next Page
Loading...
Need help?
General
