Mitsubishi MELSEC-A series Operating Manual

2. LET’S TRY USING THE A8PUE
ELSECIA
2.3 Let’s Try Monltorlng the Sequence Program
The sequence program written in Section 2.2.1 and modified in Sections 2.2.3
to 2.2.5 is shown below.
This section shows how
to execute the sequence program and monitor a bit
device and a word device.
0 LD X000
1 OR YO10
2
ANI X001
3 OUT YO10
4 OUT TO KlOO
5 LD TO
6 + K80 K5 020
5
13 MOV D20 K2Y018
18 END
[General description of the operations]
The program is as follows:
Timer
TO goes ON when X0 is turned ON. And then, Y18, YlA, YlC, and Y1E
go ON after 10 sec. (The Y18, YlA, YlC, and Y1E LEDs of the AY40’s output
module all light.)
Now, let’s try executing and monitoring the sequence program written in
Section 2.3.1.
2-11

Mitsubishi MELSEC-A series Specifications

General

Brand	Mitsubishi
Model	MELSEC-A series
Category	Controller
Language	English