Mitsubishi OUTLANDER User Manual

3-170
Features and controls
3
Driving range display
Shows the approximate driving range (how many more miles
or kilometers you can drive). When this driving range falls
below 30 miles (50 km), “---” is displayed.
Refuel as soon as possible.
N
OTE
● The driving range is determined based on the fuel con-
sumption data. This may vary depending on the driving
conditions and habits. Treat the distance displayed as just
a rough guideline.
● When you refuel, the driving range display is updated.
However, if you only add a small amount of fuel, the cor-
rect value will not be displayed. Fill to a full tank when-
ever possible.
● When your vehicle is stopped on an extremely steep hill,
the driving range value may, change. This is due to the
movement of fuel in the tank and does not indicate any
breakdown.
● The display setting can be changed to the preferred units
(miles or km).
Refer to “Changing the function settings (With ignition
switch in the “ON” position)” on page 3-178.
Average speed display
This displays the average speed from the last reset to the
present.
There are 2 types of mode settings as follows.
For details on how to change the average speed display setting,
refer to “Changing the function settings (With ignition switch
in the “ON” position)” on page 3-178.
Manual reset mode
● When the average speed is being displayed, if you hold
down the multi-information meter switch, these calcula-
tions will be reset to zero.
● When the ignition switch is turned to the “ON” position
from the “ACC” or “LOCK” position, the mode setting
changes automatically from manual to auto.
Auto reset mode
● When the average speed is being displayed, if you hold
down the multi-information meter switch, these calcula-
tions will be reset to zero.
● When the ignition switch has been set to the “ACC” or
“LOCK” position for about 4 hours or more, the average
speed display will automatically reset.
N
OTE
● The average speed display and the average fuel consump-
tion display can be reset separately in both auto reset
mode and manual reset mode.
● “---” is displayed when the average speed cannot be mea-
sured.
● The initial (default) setting is “Auto reset mode”.
● The display setting can be changed to the preferred units
(mph or km/h).
Refer to “Changing the function settings (With ignition
switch in the “ON” position)” on page 3-178.
● Disconnecting the battery cable will erase from memory
the manual reset mode or auto reset mode setting for the
average speed display.
BK0122500US.book 170 ページ ２０１０年５月１２日 水曜日 午前１１時１１分

Mitsubishi OUTLANDER Specifications

General

Brand	Mitsubishi
Model	OUTLANDER
Category	Automobile
Language	English