Mitsubishi Q Series User Manual

5 - 1 5 - 1
MELSEC-Q
5 UTILITY PACKAGE (GX Configurator-TC)
5 UTILITY PACKAGE (GX Configurator-TC)
5.1 Utility Package Functions
Table 5.1 shows a list of the utility package functions.
Table 5.1 Utility Package (GX Configurator-TC) Function List
Function Description
Reference
section
(1) Make initial setting for Q64HLC channel-by-channel.
Set the values of the items which require initial setting.
•CH
Input Range
•CH
Sensor compensation value setting
•CH
Primary delay digital filter setting
•Cold junction temperature compensation
mode setting
•CH
Unused Channel Setting
•CH
Upper Limit Setting Limiter
•CH
Lower Limit Setting Limiter
•CH
Setting Change rate Limiter
•CH
Upper output limiter
•CH
Lower output limiter
•CH
Output variation limiter
•CH
Alert 1 to 4 Mode Setting
•CH
Alert Setting Value 1 to 4
•Alert dead band setting
•Alert delay count
•CH
Loop disconnection detection judgment
time
•CH
Loop disconnection detection dead
band
•CH
Forward/Reverse Operation Setting
•CH
Control mode
•Approach band
•Soak time criteria
•CH
Stop mode setting
•PID continuation
•CH
AT bias
•CH
AT differential gap
•CH
AT additional lag
•CH
Set value (SV) setting
•CH
Proportional band (P) setting
•CH
Integral time (I) setting
•CH
Derivative time (D) setting
•CH
Control response parameter
•CH
Program control RUN/RESET
•CH
Execution pattern
•CH
Start mode
•CH
Time scale
•CH
Zone 1 to 7 upper limit
•CH
Zone 1 to 8 Proportional band (P)
setting
Integral time (I) setting
Derivative time (D) setting
Control response parameter
•CH
Program pattern 1 to 3
Final segment
Pattern link
Iteration
Output time of pattern end
Wait zone
Segment 1 to 16
Set value (SV) setting
Executing time
Zone PID data No.
•Cascade bias
•Cascade gain
•CH
Scaling range upper limit value
•CH
Scaling range lower limit value
•CH
Scaling width upper limit value
•CH
Scaling width lower limit value
Initial setting
(2) The initially set data are registered to the programmable controller CPU parameters, and when
the programmable controller CPU is set to the RUN mode, they are written to the Q62HLC.
Section 5.4
(To next page)
5

Mitsubishi Q Series Specifications

General

Brand	Mitsubishi
Model	Q Series
Category	Control Unit
Language	English