EasyManuals Logo
Home>Mitsubishi>Engine>S12R

Mitsubishi S12R Service Manual

Mitsubishi S12R
214 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #171 background imageLoading...
Page #171 background image
9 LONG-TERM STORAGE
Mitsubishi Diesel Engine S12R OPERATION & MAINTENANCE MANUAL
171
Pub. No. 291Y1-40720 Revision: 5
9 LONG-TERM STORAGE
This chapter describes the long-term storage procedure.
Storing Engine in Inoperable
Condition
If you will store this engine in inoperable condition
for 3 months or longer (1 year at longest), follow the
procedure shown below.
• Devices and equipment outside the
scope of our supply are included in the
facility. For the details, refer to such a
document as the specifications sheet
prepared by the generator supplier.
• For the devices and equipment outside
the scope of our supply, refer the
corresponding manual of the generator
and the supplier's operation manual.
Storage - Prepare (Rust-
preventive Measure)
Keep away from fire, when working
with flammable substances such as
volatile corrosion inhibitor or rust
preventive oil.
* They may cause a fire.
Keep away from fire, when working
with flammable substances such as
grease.
* They may cause a fire.
* When handling grease, obey the
manufacturer's SDS.
If the engine is stored for 3 month or
longer (up to 1 year), apply rust-
preventive measure properly.
* Otherwise, the internal engine parts and/or
sliding parts will rust, which may cause damage
to the devices.
* Follow the storage procedure described in this
Operation & Maintenance Manual.
Use volatile corrosion inhibitor and
rust preventive oil recommended by
us.
* If a product other than the recommendation is
used, the internal engine parts may be rusted
due to insufficient anti-rust effect.
Use new (immediately after opened)
desiccant.
* If you use a product which has been unused for
a long time since its package was opened,
moisture absorbency may be weakened, and
may cause the internal engine parts and/or
sliding parts to rust.
After stopping the engine, spray
volatile corrosion inhibitor while
cranking the engine for at least 2
times.
* Otherwise, accumulated and hardened anti-
corrosive agent on the piston may block turning.
When handling volatile corrosion
inhibitor or rust-preventive oil, wear
protective gears such as protective
mask or protective glasses, and obey
the manufacturer's SDS.
* If such products are breathed in or comes in
contact with the skin, serious personal injury
may occur.
When working with grease, wear
suitable personal protective
equipment such as protective
eyeglasses, rubber gloves, working
clothes with long sleeves and long
trousers.
* If grease comes into contact with your eyes, it
will cause irritations.
* When handling grease, obey the
manufacturer's SDS.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi S12R and is the answer not in the manual?

Mitsubishi S12R Specifications

General IconGeneral
BrandMitsubishi
ModelS12R
CategoryEngine
LanguageEnglish

Related product manuals