Mitsubishi S3Q2 User Manual

REASSEMBLY OF BASIC ENGINE
7-12
3. Reassembling flywheel
3.1 Installing rear plate
(1)
Install a new rear plate gasket.
(2) Install the rear plate aligning with the dowel pins.
Tighten the mounting bolt to the specified torque.
Note: Install the starter to the rear plate in advance to
facilitate the subsequent reassembly.
Installing rear plate
3.2 Installing oil seal case
&$87,21
Be very careful not to damage the oil seal
(1) Apply engine oil to the entire circumference of the oil
seal.
(2) Install the oil seal into the oil seal case.
(3) Apply engine oil to the engine circumference of the oil
seal lip.
(4) Install the O ring into the oil seal case, and install the
assembly onto the near plate.
Installing oil seal
3.3 Installing flywheel
&$87,21
The person who holds the pulley must be very careful
to assure safety by communicating with the person
who is installing the flywheel.
(1) One person must firmly hold the pulley with a wrench
to prevent the crankshaft from turning.
(2) Screw the guide bolt into the rear end of the crankshaft.
(3) Align the bolt hole of flywheel with the guide bolt and
install the flywheel to the crankshaft.
(4) Temporarily tighten bolts.
(5) Remove the guide bolt and temporarily tighten the last
bolt.
(6) Tighten the flywheel bolts to the specified torque.
Installing fly wheel
Crank case
Gasket
Rear plate
O-ring
Oil seal case
Oil seal
83 ± 5 N·m
{8.5 ± 0.5 kgf·m}
[61 ± 3.6 lbf·ft]
Dowel pin
Fly wheel

Mitsubishi S3Q2 Specifications

General

Brand	Mitsubishi
Model	S3Q2
Category	Engine
Language	English