Mitsubishi SRK25CES User Manual

-
27
-
Fixing on concrete wall
Use of nut anchor Use of bolt anchor
Bolt
(M6 × 12)
Mounting
board
Nut
(M6)
Mounting
board
Max. 10
Adjustment of the installation board in the horizontal
direction is to be conducted with four screws in a
temporary tightened state.
(2) Installation of indoor unit
(a) Installation of installation board
(i) Fixing of installation board
(b) Drilling of holes and fixture sleeve (Option parts)
When drilling the wall that contains a metal lath, wire lath or metal plate, be sure to use pipe hole sleeve sold separately.
(i) Drill a hole with ø65
whole core drill
(ii) Adjusting sleeve length
Adjust so that board will be level by turning the board
with the standard hole as the center.
Standard hole
(iii) Install the sleeve
(Inserting sleeve) (*Sleeve + *Inclined + *Sealing plate)
Note (1) Drill a hole with incline of 5 degree from
indoor side to outdoor side.
Indoor side Outdoor side
Cut off the sleeve
collar in case of
drawing piping out
to rear.
Cut off the sleeve
collar that can be
seen from beneath
the unit.
Wall thickness
+ 1.5 cm
Indoor side
Outdoor side
Turn to
tighten
Paste
View of sleeve when installed
Inclined flange
Sealing plate
Sleeve
Indoor side Outdoor side
Look for the inside wall structures (Intersediate support or
pillar and firaly install the unit after level surface has been
checked.)
Mating mark for level surface
450
450207.5
53.5
63.5
182.5
693
50
50 50
73.5 73.5
100
8.5284.25.3
44.5
44.5
47.5220.5
40 Speace
for service
15 Speace for service
Speace for
service
Speace for
service
Indoor unit
Installation board
Piping hole (ø65) Piping hole (ø65)
Drain hose 515 (ø16)
Piping for liquid 603.5
Piping for Gas 533.5
INSTALLATION SPACE (INDOOR UNIT) (FRONT VIEW)
Unit : mm

Mitsubishi SRK25CES Specifications

General

Brand	Mitsubishi
Model	SRK25CES
Category	Air Conditioner
Language	English