Managing the Wireless WallPlates
Motorola, Inc. 570510-001-00 rev A Page 30 of 50
P
P
e
e
r
r
-
-
W
W
L
L
A
A
N
N
C
C
o
o
m
m
m
m
a
a
n
n
d
d
s
s
Use the following commands to configure per-WLAN parameters:
Command What it does
wifi wlan profile add Create a new WLAN by assigning an SSID as a profile name
wifi wlan profile config Broadcast SSID: enable/disable
Client Isolation: enable/disable
Client inactivity timeout: 300-86400 (sec)
DTIM Period: 1-255
Wifi wlan profile security None:
Dynamic-WEP: (uses 802.1x authentication)
Static WEP: Key length, WEP key, Passphrase, Open or Shared
WPA-personal: Preshared-key, version (WPA, WPA2, both)
WPA-enterprise: version (WPA, WPA2, both), wpa2-pre-authentication
M
M
o
o
n
n
i
i
t
t
o
o
r
r
t
t
h
h
e
e
W
W
L
L
A
A
N
N
s
s
a
a
n
n
d
d
r
r
a
a
d
d
i
i
o
o
s
s
Use the following commands to monitor the configuration and operational status of the WLANs:
Command What it does
show wifi wlan Config: displays administrative status
Status: displays operational status
Statistics: displays detailed WLAN statistics. Additional options are
general, rate, size and qos
show wifi wlan profile Config: displays administrative status
Status: displays operational status
show interface wireless
status
Displays operational status of the wireless radio
Show interface wireless
statistics
Displays detailed statistics of the wireless radio
show wifi client statistics Displays information about a connected client including MAC address, WLAN,
and SSID
Expanded Statistics and Status
Most “show” commands display high level, important information for quick review. To see more detailed status or
statistics, specify the actual radio or WLAN. For example;
displays high level status of all active radios show interface wireless status
displays detailed status of an individual radio show interface wireless status radio1
To Next Page
Loading...
Need help?
General
