RADIUS network authenticated login
Motorola, Inc. 570510-001-00 rev A Page 33 of 50
W
W
a
a
l
l
l
l
P
P
l
l
a
a
t
t
e
e
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
Basic Configuration
The following commands will enable a basic network configuration. The T3 system will ignore the text following the
“#” comment character.
NOTE: Telnet is recommended due to the TCP flow control. Ranged commands can take several seconds to
execute. If the console is used to paste a long string of commands, set a Line Delay of 500ms on your serial program
so that the serial buffer does not overflow. If this happens, some commands may be lost or not executed.
Login using the serial console or telnet to the default IP address.
#BASIC IP AND SYSTEM CONFIGURATION
####################################
dhcp server enable
ip config ip <your IP address> mask <your mask> gateway <your gateway>
ip private enable
vlan enable
vlan mode local port remote tag
system reboot
#ENABLE AND CONFIGURE ONE WLAN
##################################
wifi wlan profile add <your SSID>
wifi wlan config wlan(1-25)-1 profile <your SSID>
wifi wlan enable wlan(1-25)-1
#ENABLE AND CONFIGURE DSL PORTS AND REMOTE ETHERNET PORTS
################################################################
interface dsl config port(1-25) max-down 10 max-up 10
interface remote enable port(1-25)-(1-2)
#ENABLE THE LINE POWER AND RADIO
##################################
interface wireless enable radio(1-25)
interface dsl po en port(1-25)
#REBOOT
########
system reboot
Tools Required:
Number 2 Philips head screwdriver
Note: if using a power drill, set the torque clutch to 5 in-lbs.
Components provided with the MC-802 WallPlate:
1 – MC-802 WallPlate
1 – RJ11 wall jack mounting adapter
1 – 100mm (4”) RJ11 pigtail cable
2 – 6-32 thread forming Philips head screws, 0.375”
To Next Page
Loading...
Need help?
General
