Motorola 549478-001-00 - PowerBroadband EthernetXD M2a WallPlate Switch User Manual

RADIUS network authenticated login
Motorola, Inc. 570510-001-00 rev A Page 38 of 50
Tag-based VLAN Mode
Tag based mode is fully 802.1Q VLAN compliant. You must explicitly configure the
Egress and Ingress rules for each port and each VLAN. On the webUI, use the 802.1Q
TAG-BASED VLAN menu to configure VLANs.
The T3 Switch and WallPlate can operate independently. Be sure to configure all ports
on the Switch and the WallPlates for proper operation.
Port-based VLAN Mode
Port based VLAN is also called Port Isolation or Port Privacy in other switches.
When operating in port-based mode, the T3 Switch will ignore 802.1Q VLAN tags. Port
isolation is based on a VLAN Map. On the webUI, use the PORT-BASED menu to see
the VLAN Map and change the mapping. See below for more details.
Note: The Switch operates in port-based or tag-based mode; whereas the WallPlates
only operate in tag-based, or disabled. This allows for special case configurations
where the WallPlates do all the 802.1Q VLAN tagging, while the Switch maintains port-
to-port privacy.
V
V
L
L
A
A
N
N
c
c
o
o
m
m
m
m
a
a
n
n
d
d
s
s
All VLAN configurations are also available from the webUI.
vlan config default
Restore VLAN configuration to default
vlan enable/disable
Enable or disable VLAN support. Requires a system reboot after issuing this command.
vlan add
Create or modify a VLAN and optionally assign a name.
vlan delete
Delete a VLAN Group. Remove all ports that are members of the group before deleting
the group.
vlan membership add
Add or delete a VLAN from a port. Allows the VLAN to transmit on the port
vlan membership egress
Sets how a VLAN will egress; with a tag or without. By default, packets will transmit
untagged unless specified using this command. Note this command does NOT apply to
WallPlate ports
vlan membership delete
Deletes a port from a VLAN membership
vlan interface ingress
Ingress command: Assign the PVID for a port. This VLAN ID will be assigned to all
packets received untagged on this port
vlan interface egress
Set the Egress mode on any CPE port. This command does not apply to T3 Switch
ports
vlan interface igmp
Assign VLAN for IGMP packets
vlan interface mgmt
Assign VLAN for layer 2 security for all management traffic
vlan mode
Set the mode of operation on the Switch and the WallPlates. Options are IEEE 802.1Q
tag-based, or Port-based. Note: WallPlates only support tag-based or disabled.
vlan port-group
CLI command to add ports to a Port-based VLAN.

Motorola 549478-001-00 - PowerBroadband EthernetXD M2a WallPlate Switch Specifications

General

Brand	Motorola
Model	549478-001-00 - PowerBroadband EthernetXD M2a WallPlate Switch
Category	Cordless Telephone
Language	English