7Getting started
Connecting the base
1. Plug the telephone line cord into the socket marked on the underside of the base.
2. Plug the power adaptor into the socket marked on the underside of the base and
plug the other end into the mains power wall socket. Switch on the mains power.
Charging the handset
1. If you are charging the battery for the rst time, place the handset on the base to
charge for at least 24 hours continuously.
2. When the handset is fully charged, the icon will appear steady on the display. Plug
the other end of the telephone line cord (make sure that one end is already plugged
into the base) into the telephone wall socket.
NOTE
You cannot access the battery in the handset. Do not attempt to remove the battery, as
you may damage the phone. If you need to replace the battery, contact customer service
helpline found in this user guide.
Connecting the handset and charger
(for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process for all the
handsets and chargers.
To Next Page
Loading...
Need help?
General
