essentials
11
battery charging
New batteries
are not fully
charged. Plug
the battery
charger into
your phone and
an electrical
outlet. Your
phone might
take several seconds to start charging the
battery. When finished, your display shows
Charge Complete
.
Tip:
Relax, you can’t overcharge your battery.
It will perform best after you fully charge and
discharge it a few times.
You can charge your battery by
connecting a
cable
from your
phone's mini-USB port to a USB
port on a computer. Both your
phone and the computer must be turned on,
and your computer must have the correct
software drivers installed. Cables and
software drivers are available in
Motorola Original data kits, sold separately.
If your battery is completely dead and you
plug in a
cable
to charge it, your keypad and
display might not light up. Your battery will still
charge.
3
To replace the
battery door, set the
door against the
phone and then slide
it into place.
To Next Page
Loading...
Need help?
General
