27
PROGRAMMING FEATURES
Reading CTCSS / DPL Values
Cycle through the features available for
configuration by short pressing the PTT button
until you hear the current code. The radio
moves to the programming CTCSS/PL codes
mode.
Enter a new code value using the SB1 and SB2
buttons.
The XT Series radios have up to 219 codes
available. For more information, refer to
“Frequency and Code Charts” on page 46.
Reading Auto-Scan Values
After hearing the CTCSS/DPL codes, short
pressing the PTT button moves you to Auto-
Scan mode.
Auto-Scan has only two values:
• Enabled
• Disabled
Modify Auto-Scan values using SB1 and SB2
buttons.
Saving Settings
Once you are satisfied with the settings, you
can either:
• short press the PTT button to continue
programming,
• long press the PTT button to save and return to
‘Idle’ Programming Mode, or
• long press the PTT button twice to exit ‘Idle’
Programming Mode and return to the normal
radio operation.
Note:
• To exit the programming mode without saving,
turn OFF the radio.
• If you ‘roll-over’ to the beginning of ‘Idle’
Programming Mode, you hear “Channel
Number” and the LED Indicator blinks green
again. All changed values will be automatically
saved.
63M03_A_BRCAN_en.book Page 27 Monday, November 19, 2018 11:30 AM
To Next Page
Loading...
Need help?
General
