13
PRELIMINARY
Programming Mode
k
Cloning
The XTN Series radios have cloning capability when connected via the Multi Unit
Charger (MUC). Cloning enables rapid fleet reconfiguration because all selectable
settings are sent to the target unit. The target radios must be placed behind the
source radio, please refer to the MUC instructions included with this accessory.
Resetting Factory Defaults
All selectable features can be reset to factory defaults by turning the radio on while
holding M and \ buttons simultaneously for five seconds.
Note: The radio cannot be reset if Manager Lockout is enabled.
• Make sure k is accessed. Please refer to Programming
Mode on page 9.
• The source radio enters Cloning Mode through an extended
press of J. Pressing J again, will clone additional radios.
• Either p for pass or f for fail shall appear on the display.
• Only the source radio needs to be in Clone Mode, and both
radios will indicate if cloning was successful.
6881038B80.book Page 13 Thursday, August 30, 2001 5:33 PM
To Next Page
Loading...
Need help?
General
