Page 8
Parts Overview
mrcool.com
Indoor unit
1. Drain pump
(drain water from indoor unit)
2. Drain hose
3. Air outlet
4. Air inlet
5. Air-in grill
6. Display panel
7. Remote controller
Outdoor unit
8. Refrigerant connecting pipe
9. Connective cable
10. Stop valve
11. Fan hood
(C) With cassette type air handler
Multi-Zone System Parts Diagram
Fig. 1.4
Five Zone
Four Zone
Three Zone
Two Zone
Instructions for Unpacking & Packing the
Indoor & Outdoor Units
NOTE: Please keep all packaging materials
included with the indoor and outdoor units in
case they are needed for future use.
Unpacking:
Indoor Unit:
1. Carefully cut the sealing tape on the carton with a
knife.
2. Remove the sealing nails on the top of the carton.
3. Open the carton.
4. Take out the middle support plate (if included).
5. Take out the accessory package and connecting
wire (if included).
6. Lift the unit out of the carton and lay it on a flat
surface that is sturdy enough to hold its weight.
7. Remove the left and right packing foam, or upper
and lower packing foam (depending on unit), and
untie the packing bag.
Outdoor Unit:
1. Cut the packing belt.
2. Remove the unit from the carton.
3. Remove the foam from the unit.
4. Remove the packing bag from the unit.
Packing:
Indoor Unit:
1. Put the indoor unit into the packing bag.
2. Attach the left and right package foam, or upper
and lower packing foam (depending on unit) to
the unit.
3. Place the unit into the carton, then put the
accessory bag in.
4. Close the carton and seal it with packaging tape.
Outdoor Unit:
1. Put the outdoor unit into the packing bag.
2. Put the bottom foam into the carton.
3. Place the unit into the carton, then put the upper
packaging foam onto the unit.
4. Close the carton and seal it with packaging tape.
To Next Page
Loading...
Need help?
General
