Important
Type the password, up to eight characters in length, and press <Enter>. The password
typed now will replace any previously set password. You will be prompted to conrm the
password. Retype the password and press <Enter>. You may also press <Esc> to abort
the selection and not enter a password.
To clear a set password, just press <Enter> when you are prompted to enter the
password. A message will show up conrming the password will be disabled. Once the
password is disabled, the system will boot and you can enter Setup without entering
any password.
When a password has been set, you will be prompted to enter it every time you try to
enter Setup/ System. This prevents an unauthorized person from changing any part of
your system conguration.
About Supervisor Password & User Password:
Supervisor password: Can enter and change the settings of the setup menu.
User password: Can only enter but do not have the right to change the settings of the
setup menu.
User Access Level
This item is used to limit the user access level.
Passwrod Check
This species the type of BIOS password protection that is implemented. Settings are
described below:
Option Description
[BIOS] The password prompt appears only when end users try to run Setup.
[System] A password prompt appears every time when the computer is powered
on or when end users try to run Setup.
Save Supervisor Password to
This item is used to assign a place to save the supervisor password.
▶
▶
▶
To Next Page
Loading...
Need help?
General
