Promise FastTrak 579 Parallel ATA / Serial ATA RAID Introduction
5-17
1. Boot your system. If this is the first time you have booted with the FastTrak 579
RAID controller and drives installed, the Promise onboard BIOS will display the
following screen.
2. Press the Ctrl-F keys to display the FastBuild Utility Main Menu.
3. Press 1 to display the Auto Setup Menu below. This is the fastest and easiest
method to creating your first array.
Create Your RAID Disk Array Under DOS
MSI Reminds You...
- Before installing the driver into an existing system, backup any
necessary data. Failure to follow this accepted PC practice could
result in data loss.
- The BIOS Configuration pictures shown below is for your reference
only, and may vary from actual ones.
To Next Page
Loading...
Need help?
General
