MS-6702E ATX Mainboard
5-20
4. Press the arrow keys to highlight the drive with the existing data to be copied. This
is the Source drive. Note that all data on the target drive will be erased. Make sure
you choose the correct source drive.
5. Press Ctrl-Y to Save selection and start duplication. The following confirmation
screen will appear.
6. Select Y to continue. If you choose N, you will return to the Main Menu. Once you
select Y, the following progress screen will appear. The process will take a few
minutes. When the array is created, the screen will return to the Main Menu.
7. Press Esc to exit the FastBuild Utility.
8. Partition and format the array, using your operating system, as if it were a new
single disk drive.
9. Proceed to Install Software Drivers to install your operating system and/or FastTrak
driver.
To Next Page
Loading...
Need help?
General
